|Public Works > Water
• Where does my water come from?
• Big Valley Well 1 - 395 feet deep
• Big Valley Well 2 - 537 feet deep
• Lincoln Road Well - 320 feet deep
• Pugh Road Well - 310 feet deep
• Westside Well - 650 feet deep
• Why is my water sometimes brown?
The culprit is the presence of the minerals iron and manganese. Poulsbo's drinking water sources are tested for these minerals on a regular basis and results are within the protective standards determined by the Washington State Department of Health.
• Will elevated levels of iron or manganese harm my health?
It is unlikely that the discolored water would cause any health problems. Discolored water is mainly an aesthetic issue.
• Where does iron and manganese come from?
The minerals may be coming from a number of sources, here are some typical possibilities:
• The pipes in your home may be rusty. This can happen if you have older, galvanized iron plumbing. Galvanized plumbing has a silvery color, whereas copper pipe is orange-colored. Galvanized pipe was commonly used in home plumbing prior to the mid-1960s.
• Your hot water tank is rusting or sediments have accumulated in the hot water tank. This would not affect your cold water.
• Naturally-occurring sediments in the water main in the street have been stirred up. This can happen during a water main break, when the fire hydrant in your area has been used, when the City is performing annual water main flushing to remove sediments, or from other circumstances.
• Discolored Water Flushing Instructions
Follow the simple steps below if you discover discolored water in your home.
Discolored water is the result of the minerals and iron in the mains being stirred up from high flow situations, which may occur while performing maintenance, during fire fighting or excessive water usage due to warm weather. The discolored water is SAFE as it is continually checked and tested.
Whenever you have discolored water, you should not use any hot water. You need to wait until you get the cold water clear first.
Go to an outside hose bib or cold water faucet in the bathtub and let the water run for a minute or two, no longer.
After that, you need to do the same thing to each individual cold-water faucet inside your home.
• What does the City add to our water?
The City adds chlorine and fluoride to your water.
CHLORINE: Chlorine is added to drinking water to eliminate harmful bacteria that may be found in water. The amount of chlorine we add to the water is checked daily and is kept at between .2 and .6 parts per million.
FLUORIDE: Fluoride is added to the water to help prevent tooth decay. We add enough fluoride to our water to keep a residual level of .8 parts per million and we test the level daily.
• When should I water my lawn?
• If I have questions about my water, who can I contact?
If you have any questions concerning your water, please contact Keith Svarthumle, at the Public Works Department (360) 394-9755 Monday-Friday from 7:00am to 3:30pm, excluding holidays.